AUSTRALIAN
MADE
AUSTRALIAN
OWNED

WALL, FLOOR & MOSAIC - PRE-TILING

SEAL USING


Note:   Undercoat / Primer where required, is Sealit Multi Purpose "Soak in Mix"
i.e..: 50% Sealit M.P. & 50% Water

DIRECTIONS

  1. Apply one coat of neat Sealit Multipurpose or one liberal coat of 'Soak in Mix', (50% Sealit Multipurpose, 50% water), to the surface to be tiled, for bonding and moisture proofing.

  2. Allow to dry.

APPLICATION

Best method - Low pressure airless spray, pump up garden spray or roller.

 

COVERAGE

Neat Sealit Multipurpose - Approximately 10m2 per litre.

'Soak in Mix', (50% Sealit Multipurpose, 50% water) - Approximately 5m2 per litre.

i.e. flat masonry surface - approx 100sqm / 20L pail - two coat application.

 

WARNING / NOTES

Sealit Multipurpose is not recommended as a final coating for traffic areas, tables, seats etc., or non porous surfaces; i.e. ceramic tiles, glazed bricks, glass etc.

During the curing period, (4-12 months), clear Sealit Multipurpose may show up slightly cloudy when wet. This will disappear when the surface dries out.

Wash all equipment immediately in water. If product has dried on equipment, clean with a petrol or mineral turpentine dampened cloth (Taking normal safety precautions).

 

GUARANTEES

Product guarantees are available to all approved applicators.

IMPORTANT
Directions for preparation and application are clearly written on the labels - Please follow them!
All instructions are a guide only - situations may vary and no liability is taken by Shalex Industries Pty Ltd. or the author – Product guarantees Issued by approved applicators only.
Back to Shalex Industries homepage