|
AUSTRALIAN
MADE |
 |
AUSTRALIAN
OWNED |
LEAKING SHOWER / BATHROOM TILES
(GENERALLY CAUSED BY LEAKING GROUT)
DID YOU KNOW?... YOU CAN REPAIR A LEAKING TILED SHOWER BASE
FOR UNDER $14.00
(WITH A SHALEX'S SEALIT MULTIPURPOSE 500ml BOTTLE)
Why pay hundreds of dollars rebuilding your shower? Shalex's Sealit Multipurpose has had a fantastic success rate with this simple D.I.Y. treatment!
| SEAL USING |
|
Note: Undercoat
/ Primer where required, is Sealit Multi Purpose "Soak in
Mix" |
DIRECTIONS
-
Apply one coat of 'Soak in Mix', (50% Sealit Multipurpose, 50% water), to the leaking tiled surface.
-
Wipe off the excess.
-
Allow to dry.
-
Apply one coat of neat Sealit Multipurpose.
-
Allow to dry.
- Remove excess, unwanted dry Sealit Multipurpose from tiles with a cloth dampened with petrol or thinners.
APPLICATION
Best method - Sponge, or brush.
COVERAGE
Neat Sealit Multipurpose - Approximately 10m2 per litre.
'Soak in Mix', (50% Sealit Multipurpose, 50% water) - Approximately 5m2 per litre.
i.e. flat masonry surface - approx 100sqm / 20L pail - two coat application.
WARNING / NOTES
Sealit Multipurpose is not recommended as a final coating for traffic areas, tables, seats etc., or non porous surfaces; i.e. ceramic tiles, glazed bricks, glass etc.
During the curing period, (4-12 months), clear Sealit Multipurpose may show up slightly cloudy when wet. This will disappear when the surface dries out.
Wash all equipment immediately in water. If product has dried on equipment, clean with a petrol or mineral turpentine dampened cloth (Taking normal safety precautions).
GUARANTEES
Product guarantees are available to all approved applicators.
| IMPORTANT Directions for preparation and application are clearly written on the labels - Please follow them! All instructions are a guide only - situations may vary and no liability is taken by Shalex Industries Pty Ltd. or the author – Product guarantees Issued by approved applicators only. |
